Using Slic3r Prusa Edition preview to troubleshoot prints

Slic3r Prusa Edition provides very powerful troubleshooting capabilities in the form of Preview mode.

Note

These notes apply to the Prusa i3 Mk3 printer. If you are using a different printer, please verify the hardware details are same. These pages may be a bit rough as I revise them and add new material. Please check back regularly for updates.

If you have not saved the generated gcode out, your preview options are limited:

Slic3r preview with unsaved gcode

Fig. 11 Slic3r preview with unsaved gcode

Save the gcode file and more options are available:

Slic3r preview with saved gcode

Fig. 12 Slic3r preview with saved gcode

General troubleshooting guidelines

  • If your print consistently fails printing infill, take a look at speeds. Prusa defaults to very aggressive 200mm/s infill speeds, which are higher than their 170mm/s move speeds. MVS is a function of Layer Height X Extrusion Width X Speed, so high speeds with higher or wider extrusions can definitely cause problems. “11.5mm^3/s. It’s the law.”
  • If your print consistently fails at the same location, look for lots of small areas like fingers. Turn on retraction preview. If you see clusters of retractions in failure areas, they may be happening so quickly (you’ll hear the staccato of retractions) that it generates enough heat to creep into the cold zone and cause problems.
  • If you’re getting extruder clicks and bucking, look at Volumetric flow rate. Look for areas exceeding 11.5mm^3/s.

Contact and feedback

You can find me on the Prusa forums or Reddit where I lurk in many of the 3D printing-related subreddits.

Last updated on Oct 23, 2018